ANSI/ASIS PAP.1-2012 Physical Asset Protection B.7.2.3: B.7.2.3 Architectural design of the monitoring facility

What else in your programme already covers this

This control maps to 2 controls across 1 other frameworks. If you already hold one of them, the evidence you collected for it is the starting point here rather than new work.

Every mapping shown was judged rather than inferred from wording similarity, and the ones that failed review are published too. See the coverage reports and what was rejected.

Other controls in Annex B: The elements of physical asset protection – ANSI/ASIS PAP.1-2012 Physical Asset Protection

• B.1 B.1 PAP system goals: protection in depth, tolerance of component failure, balanced protection and performance specifications
• B.1.1 B.1.1 PAP systems applied through the A.4.2 risk assessment
• B.1.2 B.1.2 Security surveys by accredited professionals, with findings followed up
• B.1.3 B.1.3 Cost-benefit analysis of controls over the full life cycle
• B.1.4 B.1.4 Security convergence of physical and information security risk management
• B.1.5 B.1.5 Crime prevention through environmental design (CPTED)
• B.1.5.1 B.1.5.1 Implementing CPTED
• B.1.6 B.1.6 Site hardening on delay in depth