What does 6.2-INSTALL require?

Under section 26 of the WHS Act a PCBU that installs, constructs or commissions plant or a structure for use at a workplace must ensure, so far as is reasonably practicable, that it is installed so as to be without risks to health and safety. Installers should install according to the designer's specifications, for example isolating vibrating noise sources by mounting large heavy machines on separate bases or so that they do not directly contact the rest of the building structure, and should give potential users information about the conditions required for safe use, including maintenance requirements.

Australia Model Code of Practice Managing Noise and...

Other controls in Chapter 6 Role of designers, manufacturers, importers, suppliers and installers, and acoustic shock – Australia Model Code of Practice Managing Noise and Preventing Hearing Loss at Work

6.1-BLDG Designers of buildings and structures plan noise control from the start and minimise structure-borne noise so far as is reasonably practicable, considering reverberation, layout and workstation location relative to noise sources, vibration-isolated frames, floors and machine bases, isolated plant rooms, acoustic treatment of noisy areas including absorbent ceilings and floating floors, flexible joints, walls, floors, windows and doors with the needed transmission loss, carpeted offices, and sealed, ventilated sound-insulated control rooms
6.1-PLANT Designers of plant ensure the design is without noise risk so far as is reasonably practicable, provide noise emission values, the operating conditions when measured, the measurement methods and conditions for safe use to everyone given the design, and design out noise by preventing impacts, quieter materials, acoustic guards, enclosing noisy parts, quiet drives, motors, fans and transmissions, vibration isolation, sealed doors, cooling that avoids air jets, low-speed pipelines and ducted mufflers, allowing for maintenance
6.2-MANUF Manufacturers ensure plant and structures are manufactured without noise risk so far as is reasonably practicable, with noise emission as low as reasonably practicable where it cannot be eliminated and no new hazards introduced, using and testing the designer's safety measures and low-noise materials and techniques, and provide importers and suppliers with the emission values, measurement conditions and methods and conditions for safe use
6.2-SUPPLY Importers and suppliers ensure plant is without noise risk at supply so far as is reasonably practicable, take all reasonable steps to obtain the manufacturer's noise emission information and pass it to everyone supplied, supply all noise controls as set up in the noise test results, and provide maintenance information for safe use
6.3 Give purchasers and users the information needed for safe use, including results of calculations, analysis and testing, the noise emission values with measurement conditions and methods, peak and where relevant continuous levels, preferably sound pressure at the operator position, the Table 5 minimum test information, and safe-use instructions in a form easily understood
6.4-CONTROL Control acoustic shock in headset work: high-quality headsets with acoustic shock protection, prompt repair of damaged equipment and network faults, proper fitting, use and maintenance of headsets, reduced background noise through room and workstation design, absorption, barriers, quiet conduct, relocated office machines and managed hot-desk changeovers, training to detect warning sounds and remove headsets, turning volume down after changeover, managing psychosocial hazards, keeping mobile phones out of call centres, and baseline audiometry at commencement
6.4-INCIDENT Manage acoustic incidents: the worker removes the headset at once, moves to a break-out area where appropriate, reports the incident and symptoms and discusses continuing work; the PCBU records and logs the event, discusses the worker's ability to continue, refers persistent or severe symptoms to a GP or audiologist, investigates the internal or external cause, checks and removes damaged or faulty equipment, and reviews the noise controls and working environment

Query this from an agent

The graph holds this control, the 0 it maps to, and the evidence behind each claim, over MCP and REST.

MCP endpoint All Australia Model Code of Practice Managing Noise and Preventing Hearing Loss at Work controls